Inserting the charging cable


Buttons on the vibrator

User Manual – Multi-speed Rechargeable Vibrator

Unpacking:

  • Inside the packet, you will find the vibrator along with a USB recharging cable (with no adaptor).
  • The pin of the charging cable goes inside the back of the vibrator, as shown aside.
  • It is advisable to charge the vibrator for 3 to 4 hours before first time use.
  • You can use a laptop, power bank, or adaptor to charge your vibrator. However, it is not advisable to charge it via an adaptor due to varying amperage of different adaptors.

Usage:

  • The vibrator comes with 10 different vibration modes which you can use according to your liking.
  • To turn on the vibrator, keep pressing button (2), as shown aside, till the light of the vibrator turns on.
  • Once the vibrator is on, you can toggle between different modes by pressing button (1) and (3).
  • To turn off the vibrator, long-press button (2) again till the light goes off.
  • DO NOT use the vibrator while the charging cable is plugged in, as it might lead to electrocution.

Washing:

  • Regular washing is essential to maintain hygiene. We advise you to wash the vibrator after every use.
  • The vibrator is water splash proof so you can wash the upper part directly under a tap in running water. DO NOT immerse the vibrator completely in a bucket/tumbler as water may seep through the charging point.
  • The area below the buttons, including the charging point, shall not be brought in contact of running water. Clean it with a wet cloth instead.
  • You can also use a soft detergent or soap. Try to keep the bottom end of the vibrator (where the charging point is located) away from water as much as possible.