Instructions – Long Anal Beads Vibrator

How to unpack:

  • The vibrator comes with batteries inside it, along with an insulating round sheet placed on top of it. 
  • Hold vibrator from the area right below its button and rotate the top gently to take off the cover. You will find the piece of insulating sheet put in place. 
  • Take out the sheet and gently put the cover back on by rotating it. 

How to use:

  • The vibrator consists of a powerful vibration mode. You can start the vibrator by long-pressing the button at the top of the vibrator. 
  • To stop the vibrator, long-press the same button until the vibration stops.
  • Use good amounts of lube with the massager to avoid any unwanted friction or uneasiness.
  • Do not use a moisturizing cream or any oil-based lubricant, as it damages the surface of the massager in the long run. Use water-based lube only.

Cleaning instructions:

  • It is strongly advisable to clean the beads after every use to maintain hygiene.
  • You can clean it with water, along with washing with a soft detergent. Harsh detergents can damage the surface in the long run.
  • The vibrator is waterproof, so there is no danger of damaging it while using. However, while washing it, do not immerse it completely in water. Only wash it under a tap in running water.
  • Alternatively, you can also take the vibrator out of its pouch and then wash the beads only. Once the beads’ sleeve is completely dry, put the vibrator back on.